KYN28 indoor metal-clad withdrawable switchgear - Wone

KYN28 indoor metal-clad withdrawable switchgear

discuss personally

Basic info

Brand	ROCKWILL
Model NO.	KYN28 indoor metal-clad withdrawable switchgear
Rated voltage	7.2kV
Rated frequency	50/60Hz
Series	KYN28

Product Detail

Description ：

The KYN28 indoor metal-clad withdrawable switchgear(hereinafter short as switchgear) is a complete power distribution device for 3.6-24kV,3-phase AC 50Hz,single-bus and single-bus sectionalized system. It is mainly used for power transmission of middle/small generators in power plants; power receiving, transmission for substations in power distribution and power system of factories, mines and enterprises, and starting of large high-voltage motor, etc,so as to control, protect and monitor the system. The switchgear meets IEC298,GB3906-91.In addition to be used with domestic VS1 vacuum circuit breaker, it can also be used with VD4 from ABB,3AH3 from Siemens domestic ZN65A,and VB2 from GE, etc,it truly is a power distribution device with good performance.

Main function introduction:

Centralized (Draw-out) Layout
Armored Compartmentalization
Standardized Modular Design
Excellent performance
Flexible Maintenance

Technology parameters:

Device structure:

Photos of frontal view：

Other recommendations

More

New Knowledges

More

Differential Protection of a Generator

Differential Protection of a Generator

Generator Differential ProtectionDifferential protection for a generator primarily safeguards the stator windings against earth faults and phase - to - phase faults. Stator winding faults pose a significant threat, capable of inflicting severe damage on the generator. To protect the stator windings, a differential protection system is utilized to clear faults in the shortest time possible, thereby minimizing the extent of damage.Merz - Prize Circulating Current SystemIn this protection scheme, t

Encyclopedia

04/26/2025

Design scheme of rack-mounted structure for prefabricated cabin-type secondary combined equipment in 220kV substation

Design scheme of rack-mounted structure for prefabricated cabin-type secondary combined equipment in 220kV substation

Currently, most secondary equipment in newly - built intelligent substations is placed inside prefabricated cabins located in the switchgear area. After the cabin bodies are manufactured, secondary equipment manufacturers enter the cabins for installation and debugging, resulting in a rather complex and cumbersome construction process. A typical 220 kV intelligent substation usually requires the setup of two prefabricated cabins: one for 220 kV and one for 110 kV. Both cabins are of Type II, wit

Dyson

04/26/2025

Differential Protection Relay

Differential Protection Relay

DefinitionA differential protection relay is one whose operation hinges on the phase difference of two or more electrical quantities. It operates based on the principle of comparing the phase angle and magnitude of the same electrical quantities.ExampleTake the comparison of the input and output currents of a transmission line as an instance. If the magnitude of the input current of the transmission line exceeds that of the output current, it indicates that additional current is flowing through

Encyclopedia

04/26/2025

What is the difference between fixed-time overcurrent protection and inverse-time overcurrent protection?

What is the difference between fixed-time overcurrent protection and inverse-time overcurrent protection?

Action time characteristicsFixed-time overcurrent protection: the action time of the protective device is fixed, independent of the size of the fault current. No matter how much the fault current exceeds the setting value, as long as the action conditions are met, a pre-set fixed time will elapse before action is taken to trip or signal is issued. For example, if the set action time is 5 seconds, then when the current exceeds the set value, no matter how much it exceeds, the protection will be t

RW Energy

04/26/2025